Rough Country 244.20 - Manual (Page 18)

8. Install new brake line ext. onto rear diff using stock hardware and attach the stock brake line bracket to new bracket
using the supplied 5/16” x 1 bolt, washers, nut. Tighten using a 13mm socket and wrench. Install emergency brake
cable ext. bracket using stock hardware to frame and using the supplied 5/16” x 1 bolt, washer, and nut to attach
cable to bracket ext. Use a 13mm socket and wrench to tighten. See Photo 13 & 14.
9. Install wheels and lower vehicle on the ground and tighten leaf spring bolts using 21mm socket and wrench. Tighten
lower control arm bolts using 21mm socket and wrench.
10. Inspect all brake lines, wires and hoses make sure they are not in harms way.
Photo 14 Photo 13