Rough Country 244.20 - Manual (Page 14)

51. Install the two sway-bar drop using stock hardware use a 10mm socket and a 15mm wrench. Remove the last two
bolts from the tow hooks using a 15mm socket. Install front skid plate using stock bolts for upper mount and the sup-
plied 3/8” x 1.25” bolts and washers for lower mount. Install lower skid plate using two of the lower front skid plate
bolts and the supplied 3/8” self -tapper for the rear. Use a 14mm socket to tighten all lower bolts and a 15mm for the
upper bolts. See Photo 55 & 56.
52. Install the sway-bar using the supplied 3/8” x 1.25” bolts, washers, and nut onto the sway-bar drop mounts. Use a
14mm socket and wrench to tighten. Use stock hardware to attach sway-bar to lower control arm. Use a 13mm
wrench and a pair of pliers to tighten. See Photo 57.
53. Install the new front shock using stock hardware install shock onto truck. Use 18mm wrenches to tighten bolts . See
Photo 58.
54. THIS NTD ONLY FITS EXT. CAB TRUCKS (note on driver side the wiring harness will need to be moved to install
bracket) Enlarge the stock hole on the frame where the torsion bar cross-member hanger was mounted using a 7/16
drill. Using the supplied 7/16” x 1.25”bolts, washers, and nuts. Install the new torsion bar mount onto frame. Use the
torsion bar bracket as a template and drill the other hole in frame using a 7/16 drill. Place a washer between the tor-
sion bar bracket and frame while install second bolt into hole. Tighten the first bolt using 5/8socket and wrench. Then
install flag nut into hole on outside of frame and start the second bolt into it. Tighten using 5/8 socket and a pair of
vise grips to hold on to flag nut .Repeat step for other side. See Photo 59 & 60.
Photo 55 Photo 56
Photo 57 Photo 58
Photo 59 Photo 60