Rough Country 244.20 - Manual (Page 10)

33. Install the passenger side diff drop bracket using stock hardware. Tighten bolts using two18mm wrenches. See
Photo 31.
34. Install stabilizer #81274 using supplied hardware sleeve 1/2” x 2 1/2” bolt, washer, and nut. Tighten using a 14mm
for the stud end and a 19mm for the diff drop bracket side. See Photo 32.
35. With the diff on a table cut the top diff ear off. STAY ABOVE THE VENT TUBE. Cutting to low may cause a leak.
Clean area so there is no sharp edges. Remove the fins from the drive side of diff from the yoke back without cut-
ting into the body of the diff. Sand area so there are no sharp edges. Install the two bushing and sleeve into front
diff bracket. Install front diff bracket by remove 3 of the diff bolts on front side using a 15mm socket. See Photo 33,
34, & 35.
36. Using template cut the shown areas on the driver side lower control arm pocket. Sand and paint area. See Photo
36.
Photo 31 Photo 32
Photo 33 Photo 34
Photo 36 Photo 35