Rough Country 75138-15 - Manual (Page 7)

PowerBoard ® – Installation Instructions
Rev. Q 0713 75138 / 75143 pg. 7
Locate the rubber
wire boot on
the driver’s side
fi rewall. Cut a
small hole for the
trigger wires. Tape the leading end of the wires together. Coat with
silicon sealant. Slide the ends of the wire bundle
through the rubber boot into the cabin. The wires will
come out just above and to the left of the brake pedal.
Locate white connector panel against the
driver’s side fi rewall, behind the e-brake pedal.
Locate the three (3) connectors shown below.
Connect trigger wires as shown in chart.
2013 - Current RAM 1500 vehicles: Steps 23 - 26
2009 - 2012 RAM 1500 vehicles: Steps 27 - 31
2010 - Current RAM 2500/3500 vehicles:
Steps 27 - 31
Cut Hole in Boot
Slide Trigger Wires through
Firewall
Locate Door Ajar Wires
Wiring to Door Ajar Wires:
Important Notes
There may be two (2) Violet/Grey
wires, but only one (1) will allow
the steps to be triggered by the
front passenger door.
Some vehicles have a cover that will
need to be removed to access the
white connector panel inside the cab,
against the driver side fi rewall, and
behind the emergency brake pedal.
Remove the three fasteners shown
to remove the cover bracket.
Access Connector Panel
Vehicle 2013 RAM 1500 2009 - 2012 RAM 1500
2010 - Current RAM 2500/3500
Location Under dash on
driver’s side, on
white connector
panel, located
on three lower
connectors.
Driver’s side front corner
of engine compartment, on
underside of fuse panel,
located on a single connector.
2013 - Current RAM 1500 2013 - Current RAM 1500
2013 - Current RAM 1500
Door Ajar Color Connector
WIre Wire/Stripe Color
Driver Front Violet White
Passenger Violet / White White
Front
Driver Rear Violet / Gray Blue
Passenger Violet / Yellow Black
Rear
Cut a slit
in boot
Black White
Blue