Rough Country 664 - Manual (Page 7)

9. Install the bump stop bracket on the new spacer as shown with supplied 10mm x 55mm bolt & washers using a
15mm socket. See Photo 29. Tighten 10mm bolt to 32ft/lbs. Do not over-tighten bolt.
10. Reinstall the factory bump stop in the bump stop cup and coil spring as shown in Photo 30 in the stock location with
the stock rubber on the top of the coil spring. It may be necessary to remove the upper control arm from the
upper mount to allow the coil to be installed. If needed remove the bolt with a 18mm socket / wrench.
11. If removed, reinstall the upper control arm bolt at this time using a 18mm socket. Raising or lowering the floor jack
may be needed to align the control arm to the mount.
12. Reinstall the sway bar link on the frame with factory hardware using a 18mm socket / wrench. See Photo 31.
13. Reinstall the lower shock in the lower shock mount with the factory hardware using a 15mm socket / wrench. See
Photo 32.
14. Reinstall the tires & wheels.
15. Jack up the rear of the vehicle and remove the jack stands.
16. Lower the vehicle to the ground.
PHOTO 32 PHOTO 31
PHOTO 29 PHOTO 30