Rough Country 664 - Manual (Page 3)

7. Gently lower the floor jack under the front driver side and
place it under the passenger side lower control arm of the
vehicle.
8. Release the air box clamps that secure the top of the air
box to the bottom and remove the hose as shown in
Photo 7. Lift the air box out of the air box mount.
9. On the Passenger side remove the washer tank by
removing the plastic nut by hand and removing the rear
mount bolt using a 8mm socket/ wrench. See Photo 8 &
9.
10. Position washer tank out of the way to allow access to the
upper strut bolts.
11. Remove the upper strut nuts using a 18mm socket /
wrench. Retain the factory hardware for reuse. Lower the
floor jack gently to lower the strut from the mount.
12. Starting on the drivers side remove the wire clip from the strut as shown in Photo 10.
13. Remove the sway bar from the control arm as shown in Photo 11 using a 18mm socket. Retain the hardware for
reuse.
14. Remove the tie rod from the knuckle as shown using a 21mm socket/wrench. See Photo 12. Retain hardware.
PHOTO 7
PHOTO 8 PHOTO 9
PHOTO 10 PHOTO 11
PHOTO 12