Rough Country 664 - Manual (Page 2)

1. Jack up the front of the vehicle and support the vehicle with
jack stands, so that the front wheels are off the ground.
Chock rear wheels.
2. Remove the front tires/wheels , using a 19 mm deep well
socket.
3. Support the Drivers side lower control arm with a floor jack.
4. Remove the positive wire from the battery terminal.
5. On the driver side remove the rear most box from the
mount by releasing the clips from the box as shown in
Photo 1. Take care not to damage the clip or the box.
6. Carefully fold the box over to access the mount bolts with a
10mm socket /wrench as shown in Photo 2, 3 & 4.
7. Carefully lift the forward fuse box on the driver side of the
engine compartment and release the wiring clips. Take
care not to damage the clips. See Photo 5.
6. With the floor jack under the lower drivers side lower control ,remove the 4 stock nuts that secure the strut to the up-
per mount as shown using a 18mm socket/wrench. Retain the hardware for reuse. See Photo 6.
FRONT INSTALLATION INSTRUCTIONS
PHOTO 1
PHOTO 2 PHOTO 3
PHOTO 4 PHOTO 5
PHOTO 6