Rough Country 349.24 - Manual (Page 4)

21. Place the track bar bracket on the factory upper track bar mount. Insert the supplied ¾” x 1 3/8” long sleeve inside
the factory mount and line it up with the mounting hole. See Photo 7. Install the supplied 16mm x 80mm bolt and nut
through the bracket, sleeve and factory mount. Tighten slightly.
22. Install the 12mm x 3” bolt through the bracket and slotted existing hole in the frame cross member. See Photo 8.
The bolt should be installed from the bottom. Install the supplied square washer and lock nut. Tighten track bar hard-
ware. The track rod will be installed into the new mount after the vehicle is on the ground.
23. Install the new pitman arm into the stock location on the sector shaft, using stock hardware and torque nut to 185 ft.
lbs. See Photo 9.
24. Reinstall the drag link onto the pitman arm using stock hardware.
25. Remove the sway bar hardware using a 18mm wrench as shown in Photo 10 and allow the sway bar to separate
from the frame.
26. Install the sway bar drop bracket as shown in Photo 11 and secure to the frame using the factory hardware. Tighten
with a 18mm wrench.
27. Install the sway bar to the new bracket with the supplied 7/16” x 1 1/4” bolts, flat washers and nuts. See Photo 12.
Tighten using a 9/16” socket and wrench.
28. Raise the front axle with a floor jack to slightly compress the coil springs.
29. Install the lower end of the shocks in the stock location and tighten using stock hardware.
28. Lower vehicle to the ground. Install the tires / wheels. Install track bar on bracket with supplied 16mm x 80mm Bolt.
29. Torque the fasteners to the following specifications, Lower suspension arm cam nut-110 ft/lbs, Lower suspension
arm rear nut-88 ft/lbs, Upper suspension arm axle nut-89 ft/lbs, Upper suspension arm frame nut-62 ft/lbs, Track
Rod Bolt-110 ft/lb
Photo 6
Photo 7 Photo 8
Photo 9 Photo 10
Photo 8
Photo 9
INSTALL SQUARE WASHER ON TOP OF CROSSMEMBER
Photo 10
Photo 11 Photo 12
Photo 5 Photo 7