Rough Country 323S - Manual (Page 16)

21. Install track bar into bracket with stock bolt. You may
have to do this with truck on the ground. Tighten upper
bolt using 22mm wrench and lower with 21mm wrench.
22. With WD-40 or alcohol adjust the rubber insulator on ABS
wire so that it will fit back into clip on brake line.
See
Photo 22.
23. Cut zip tie for axle vent tube and install new zip tie and
vent tube on lower part of frame.
See Photo 23 & 24.
24. Reinstall fender wells using 8mm socket.
25. Check to make sure all fasteners are tight.
26. Reinstall the track rod in the stock location on the frame.
Tighten using a 21mm socket / wrench.
PHOTO 22
PHOTO 23 PHOTO 24
POST INSTALLATION
1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile,
fixed and heated members. Check steering for interference and proper working order. Test brake system.
2. Perform steering sweep. The distance between the tire sidewall and the brake hose must be checked closely. Cycle
the steering from full turn to full turn to check for clearance.
3. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine vehicle
service.
4. Readjust headlights to proper settings and take truck in for a front-end alignment to a qualified alignment
professional.
Thank You for choosing Rough Country for your off road needs!!!