Rough Country 585 - Manual (Page 3)

9. Install the new strut spacer on the strut with stock hardware using a 9/16” socket. Torque to 30 ft/lbs. See Photo 7.
10. Install the strut assembly into the strut tower and secure with the supplied 3/8” lock-washers & 3/8” nuts using a
9/16” wrench. See Photo 8.
11. Install the lower end of the strut in the factory location in the lower control arm with the factory hardware and using a
29mm socket and 1 1/16” wrench.
12. Reinstall the upper ball joint in the knuckle with the factory hardware and using a 21mm wrench. Reinstall the cotter
pin in the upper ball joint.
13. Reinstall the tie rod end in the knuckle with the factory hardware and using a 21mm wrench.
14. Reinstall the sway bar link in the factory location on the lower control arm with factory hardware and using a 15mm
wrench.
15. Reinstall the tires/wheels and remove the jack stands from the frame rails. Lower the vehicle to the ground.
Photo 7 Photo 8