Rough Country 280N2 - Manual (Page 11)

18. Remove the brake line from the brake line bracket using a 1/2” wrench. See Photo 46.
19. Install the new brake line bracket as shown in the stock location on the differential with stock hardware using a
13mm wrench. See Photo 47.
20. Install the brake line on the new brake line extension bracket as shown in Photo 48 with supplied 5/16” x 1 1/4” bolt,
washer & nut.
21. Swing the sway bar up and install the supplied rear links as shown in Photo 49 with supplied 1/2” x 2 1/2” bolts/
washers & nuts in lower mount and stock hardware in upper mounts. Tighten to 57 ft. lbs.
22. Install the wheels and tires.
23. Jack up the vehicle and remove the jack stands. Lower the vehicle to the ground.
24. Install the stock shocks in the new mounts with the stock hardware using a 21mm wrench. Tighten to factory
specifications.
Photo 46 Photo 47
Photo 48 Photo 49
BUMPSTOP MODIFICATION FOR AVALANCHE ONLY
1. Remove the bump stop from the stock location on the frame . Trim the bump stop as shown in Photo 50 using a
reciprocating saw.
2. Only the top portion will be trimmed as shown in Photo 51. After the bump stop has been trimmed, reinstall on the
vehicle in the stock location.
Photo 50 Photo 51