Rough Country 324S - Manual (Page 8)

29. Secure the driver side differential to the frame using the supplied 12mm x 45mm bolts, flat washers, and flange lock
nuts.
See Photo 25.
30. Secure the differential in the passenger side bracket using the supplied 12mm x 45mm bolts & flange lock nuts and
bend the stock diff wiring harness bracket up for clearance.
See Photo 26.
31. Tighten all diff bolts at this time using a 18mm / 19mm wrench.
32. Apply thread lock to supplied 12mm x 55mm bolts and install driveshaft spacer. Use a 19mm wrench to tighten.
See
Photo 27.
33. Reinstall the diff plug back in the differential and reinstall the wiring harness in the bracket. Make sure the wiring har-
ness clears the rack and pinion.
See Photo 28.
34. Install rear cross member using supplied 18mm x 150mm bolts, square washers and nuts.
See Photo 29.
35. Install front cross member using supplied 18mm x 150mm bolts, square washers and nuts.
See Photo 30. Do not
tighten at this time.
PHOTO 27
PHOTO 29 PHOTO 30
INSTALL DRIVESHAFT SPACER
INSTALL REAR CROSSMEMBER INSTALL FRONT CROSSMEMBER
PHOTO 25
REINSTALL DIFF/ BRACKET ON FRAME
PHOTO 26
REINSTALL DIFF ON BRACKET
REINSTALL THE DIFF WIRING PLUG
PHOTO 28