Rough Country 592.20 - Manual (Page 6)

Photo 18
CARRIER BEARING DROP INSTRUCTIONS
1. For vehicles with 2 piece drive shafts, support the driveshaft, using a 15mm socket remove the bolts from the carrier
bearing bracket.
2. Lower the drive shaft and install the drop bracket in the stock location. Reuse the factory hardware to secure the
carrier bearing drop bracket to the frame. Tighten hardware. Please note the direction of the drop bracket. The
bracket is installed with the tall part of the bracket toward the rear. Flat part of the bracket installs on the stock frame
location and the drive shaft carrier bearing installs on the angled part of the bracket. See Photo 1.
3. Using the supplied 7/16” x 1 1/2” bolts, secure the carrier bearing to the new drop bracket as shown in Photo 2.
Toward rear
Photo 1 Photo 2