Rough Country 592.20 - Manual (Page 3)

14. Attach the lower control arm to the axle using the stock hardware. Do not tighten at this time.
15. Insert the end of the lower control arm into the radius arm drop bracket. Bolt into place using a 3/4” x4.75” bolt, nut
and washer provided in the kit bag. See Photo 7. Using a 1 7/8” wrench tighten the jam nut against the arm body.
Center of bushing to center hole of opposite bushing should be 36 1/8”
16. Reattach the ABS wire to the upper control arm. See Photo 8.
17. Repeat step 12-18 on the opposite side.
11. Insert bushings, and sleeves from kit bag into the upper control arm. See Photo 5.
12. Attach the upper control arm to the radius arm bracket in the top hole. Bolt into place using a 3/4” x4.75” bolt, nut
and washer provided in the kit bag. Do not tighten at this time
13. Attach the control arms to the axle using the stock hardware. See Photo 6. It may be necessary to use the rear
nut from the frame mount due to some models having the radius arm nut welded to the radius arm.
Photo 5 Photo 6
Photo 7 Photo 8