Atdec Visidec VFS-DH Installation manual - Manual (Page 2)

Leave slack
in cables
Cable
Balls (x6)
LOOSEN
TIGHTEN
Top of
Display
There are two mounting hole configurations:
• 75 x 75mm
• 100 x 100mm
from the Hardware supplied to suit
your Display.
Mounting Screws (x4)
VESA Plate
100mm
75mm
75mm
100mm
Back of Display
(Repeat steps 4 to 7 for each Display)
Installation Complete
C
No portion of this document or any artwork contained herein should be reproduced in anyway without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 01.09.12
Step 5. Attach your Display to the Quickshift Donut
HOOK
Back of Display
Quickshift Mount.
Hook the top of the VESA plate onto the Press and hold the Release Buttons. Gently
push bottom of VESA Plate into Quickshift
Mount. Release Buttons to lock in place.
Release Button
Phillips-head Screwdriver
CLOSE OPEN
Slide the Quickshift Donut to
desired position. Close the lever to lock the
Quickshift Donut in place.
(Optional) Insert the Security Screw, and
tighten using a Phillips-head Screwdriver.
If necessary, adjust the tension
between the Donut and the Pole
using the 5mm Allen Key supplied.
TIGHTEN
PUSH
Step 7. Adjust the VESA Ball Mount
Security Screw
Open the lever to loosen the
Quickshift Donut.
SLIDE
TIGHTEN (+kg)
LOOSEN (-kg)
3mm Allen Key
Tension Plate
Position your Display to the desired viewing angle using the ±20° tilt
allowed by the VESA Ball Mount. To make any adjustments, use the
3mm Allen Key supplied. Apply half a turn at a time to each screw on
the Tension Plate to adjust evenly. If the display does not hold its
position, or is too resistant, adjust the Tension Plate located at the
rear of the VESA Ball Mount. Check the display, and adjust again if
necessary.
Step 6. Adjust the Height of the Quickshift Donut
Step 8. Cable Management
Connect cables to your Displays, routing
them down the rear of the poles. Push
the cables into the slots, using either the
Cable Balls or Cable Cilps to secure
them to the pole as shown.
Cable
Clips
Step 4. Attach the VESA Plate to your Display
Note: Ensure enough slack
is left in cables to allow for
movement. When the slot in
each pole cannot be used,
use the supplied Cable Clips
to secure the display cables.