Atdec Telehook TH-31-55-SA-PK Installation manual User Manual
Page 2
D Positioning Sliders
Step 1
Accurately position sliders at distance X as recorded in Section A. Ensure the Sliders are equally spaced along the centre Horizontal
Bar.
=
=
Slider (x2)
Grub
Screws (x2)
Step 2
Secure slider in
position and tighten
firmly with supplied
Allen Key. Ensure that
it locates into the slot
on the horizontal bar.
The grub screw should
tighten flush to
surface.
C Attaching the Brackets to the Display
M8 Screw Hole
M6 Screw Hole
M5 & M4
Screw Hole
Step 2:
Use the supplied Multi Washer as
shown above. Ensure that the tightest
fitting hole in the washer is used for
the specific sized screw. Note
distance X, for use in the
following steps.
=
=
TOP
Clinch Nuts
Multi Washer
Step 1
Attach left and right wall mount brackets to the rear of your display. Select M4, M5, M6 or M8 mounting screws to suit your display.
Ensure a minimum of two mounting screws are used per wall mount bracket. Clinch nuts must be positioned as shown (internally).
B Attach Pivot Head to Swing Arm
Step 1
Slide the Wall Mount Cover along the
Swing Arm until it snap fits onto the
wall plate.
Wall Mount Cover
Step 2
Assemble the Pivot Head
onto the Swing Arm as
shown.
M12 Screw
M12
Locking Nut
M12 Steel
Washer
M12 Plastic
Washer
Wall Plate
End of
Swing Arm
E Attach the Horizontal Bar to Pivot Head
Step 1
Attach the Horizontal Bar and tighten
screws as shown.
M8x45mm
Button Screws
Pivot Head
Horizontal Bar
Step 1
Note: This operation
requires two persons.
Now that the horizontal bar is
attached to the Swing Arm
with the Sliders in place, lift
the Display with brackets
attached and hook the
Brackets over the Sliders.
Note: The brackets should
rest on the horizontal bar
with the slider between the
bracket.
F Mounting the Display
Cable
Manager Clips
Step 2
Attach the four Cable Manager Clips to
the Swing Arm by inserting the clips into
the holes. Ensure that the clips are held
firmly in place.
Swing Arm
X
Tighten
Distance X
Horizontal Bar
8mm Allen
Key
5mm Allen
Key
Note: make sure
the threaded nut
faces inwards