Atdec Telehook TH-3070-CTW-EXT-1M Installation manual - Manual

Inner hanger
Display mount
Collar Joiner
Inner hanger
Display mount
Step 2. Remove display mount
Step 1. Check Components
Component Checklist
Step 3. Add extension to set-up
Add new extension
hanger and collar
joiner to set-up as
shown
Remove Display mount from existing set-up by
undoing the screws with a 5mm allen key.
Note: retain screws for further use with extension
M8 x 10mm Screw
x12
Tools Required:
5mm allen key
Flat Panel Ceiling Mount | 1 Metre Extension
TH-3070-CTW-EXT-1M
IMPORTANT INFORMATION
!
IMPORTANT - Install Telehook Flatpanel ceiling mount 1m extension as per Installation Instructions
! The Telehook Flat panel ceiling mount plus the 1metre extension supports a maximum of 91kg (200lbs).
! The installers should satisfy themselves that the ceiling is strong enough to support the Telehook Flat panel ceiling
mount unit of 14kgs (31lbs) and the 1m extension unit of 3kgs (6.6lbs) plus the maximum allowable monitor weight
of 91kgs (200lbs). Total of 108kgs (238lbs).
! The Manufacturer recommends the use of guy wires when adding the 1metre extension to an existing set-up
! The Manufacturer accepts no responsibility for incorrect installation.
Check you have received all parts against the Component Checklist and Hardware.
1Metre Extension hanger Collar Joiner
OR
OR Extension hanger
New
Collar Joiner
Extension hanger
New 1 Metre
Extension hanger
Collar Joiner
Installation Instructions