Atdec Telehook TH-3070-UFL Installation manual - Manual (Page 2)

Installation Complete
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 21.09.12 ©
Step 5. Attach Display to the Arm/Wall Mount
Step 6. Tilt Adjustment
Step 7. Horizontal Adjustment Step 8. Cable Management
1. Hook the display to the mounting
plate.
2. Push the bottom of the display.
3. Ensure display is positioned in the
center of the mounting plate.
4. Tighten the locking screws using a
phillips head screw driver.
10°
NOTE: Depending on the weight
of your display, you may need to
use the supplied spanners to tighten
and loosen the bolts for tilt tension
adjustment.
+2°
-2°
NOTE: Depending on the weight of your display, you may
need to use the supplied spanner to tighten and loosen the
nuts for horizontal adjustment.
TIGHTEN LOOSEN
TIGHTEN
LOOSEN
HOLD
Adjustment Points
(same with the
other side)
1 HOOK
2 PUSH
Phillips Head Screw Driver
3 CENTER
Locking Screw
4 TIGHTEN
Insert cables into the four clips
provided.