Atdec Visidec VFS-Q Installation manual - Manual (Page 2)

Cable
Clips
LOOSEN
TIGHTEN
Top of
Display
There are two mounting hole configurations:
• 75 x 75mm
• 100 x 100mm
from the Hardware supplied to suit
your Display.
Mounting Screws (x4)
VESA Plate
Step 4. Attach the VESA Plate to your Display
100mm
75mm
75mm
100mm
Back of Display
(Repeat steps 4 to 7 for each Display)
Installation Complete
C
No portion of this document or any artwork contained herein should be reproduced in anyway without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 01.09.12
Step 5. Attach your Display to the Quickshift Donut
HOOK
Back of Display
Quickshift Mount.
Hook the top of the VESA plate onto the Press and hold the Release Buttons. Gently
push bottom of VESA Plate into Quickshift
Mount. Release Buttons to lock in place.
Release Button
Phillips-head Screwdriver
CLOSE OPEN
Slide the Quickshift Donut to
desired position. Close the lever to lock the
Quickshift Donut in place.
(Optional) Insert the Security Screw, and
tighten using a Phillips-head Screwdriver.
If necessary, adjust the tension
between the Donut and the Pole
using the 5mm Allen Key supplied.
TIGHTEN
PUSH
Step 7. Adjust the VESA Ball Mount
Security Screw
Open the lever to loosen the
Quickshift Donut.
SLIDE
TIGHTEN (+kg)
LOOSEN (-kg)
3mm Allen Key
Tension Plate
Step 6. Adjust the Position of the Quickshift Donut
Step 8. Cable Management
Connect cables to your Displays, routing them down the
rear of the poles. Push the cables into the slots, using
either the Cable Balls or Cable Clips to secure them to the
pole as shown.
Note: Ensure enough slack
is left in cables to allow for
movement. When the slot in
each pole cannot be used,
use the supplied Cable Clips
to secure the display cables.
Position your Display to the desired viewing angle using the ±20°
tilt allowed by the VESA Ball Mount. To make any adjustments,
use the 3mm Allen Key supplied. Apply half a turn at a time to
each screw on the Tension Plate to adjust evenly. If the display
does not hold its position, or is too resistant, adjust the Tension
Plate located at the rear of the VESA Ball Mount. Check the
display, and adjust again if necessary.
Cable
Balls