Atdec Telehook TH-3060-LPT Installation manual - Manual (Page 2)

Push bottom of Display to lock the
Display to the Wall Plate. Listen
for a ‘CLICK’.
Step 3. Attaching Tilt Brackets to Display
Step 4. Attaching/Detaching Display to Wall Plate (2 people required)
Step 5. Cable Management Step 6. Set Display Tilt
Tension Tool
TIGHTEN
LOOSEN
NOTE: If necessary use the supplied
Tension Tool to adjust the tension in
the tilt mechanism.
TOP
With the Tilt Brackets attached to
the Display, lower the Hook Plates
onto the Wall Plate. 1
2 15° TILT
OPTIONAL: For larger screens, fix the
protective self-adhesive foam pad (supplied) to
the back of the panel. Position on the bottom
edge, where the Display touches the wall.
Once the Display is securely fastened to the
Wall Plate cut or fold the Release Ties so that
they cannot be seen from front of screen.
Spacer
(OPTIONAL, used only for
recessed mounting holes)
Mounting Screw
Tilt Bracket (right)
Washer
Tilt Bracket (left)
Tension
Nut
NOTE: The Tilt Brackets must be
mounted to the Display with the
Tension Nuts facing outwards, so it
is easily accessible from the side.
1 HOOK
2
2 PUSH
Detaching Display from the Wall Plate
To detach Display from wall plate, pull and
hold both Release Ties to disengage the
locking mechanism.
Whilst pulling the Release Ties, lift the Display
to unhook from the Wall Plate.
Self-adhesive
foam pad (OPTIONAL)
PULL
Hook Plate
2 PUSH
HOOK 1
WALL
1 PULL
No portion of this document or any artwork contained herein should be reproduced in anyway without the express written consent from Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 16.02.11©
Installation Complete
Pull Display out from the wall to allow access to the cable
ports on the back of the panel.
Connect cables, and push Display back against the wall.
TIP: To push Display back against the wall, pull
bottom edge outwards then push Display backwards.
1 Holding the Display by the top and bottom edges,
pull the Display straight out from the wall.
2 Tilt Display downward as desired.