Atdec Telehook TH-3070-CT-B2B Installation manual - Manual (Page 2)

9
11
10
Tightening Tool
8
Tightening Tool
7
Refer to the TH-3070-CTL/CTS Installation Manual to complete installation
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 30.01.13 ©
Step 4. Remove the collar from Head Assembly of TH-3070-CTL/CTS
Step 5. Assemble the collar to the B2B Head Assembly
Step 6. Attach to TH-3070-CTL/CTS Pole Assembly
8
9
11
10
A. Remove the three set screws (item 7) using the 3mm Allen Key from
TH-3070-CTL/CTS.
B. Remove the set screw (item 8) using the supplied 2mm Allen Key.
C. Loosen the locking ring (item 9) using the supplied tightening tool.
D. Remove item 9 and an item 10.
E. Loosen Set Screw#1 using the supplied 2.5mm Allen Key to easily
remove item 11 and the another item 10.
Set Screw#1
9
A. Attach item 11 and an item 10 to B2B Head Assembly.
B. Insert and screw item 9 and the remaining item 10 to the installed item 11.
C. Tighten Set Screw#2 using the supplied 2.5mm Allen Key to fix item 11.
D. Tighten item 9 using the supplied tightening tool.
E. Insert item 8 using the supplied 2mm Allen Key to secure item 9.
Set Screw#2
A. Attach the B2B Head Assembly to TH-3070-CTL/CTS Pole Assembly.
B. Insert the three set screws (item 7) to secure.
NOTE: Please refer from step 8 until the last step of TH-3070-CTL/CTS
instruction manual to complete installation.
7
ATTACH
TH-3070-CTL/CTS
Pole Assembly
UNLOCK
LOCK
Completed
installation
Bottom Cover
NOTE: The two bottom covers should be
installed with exit/entry ports as shown.
Clamp Covers installed to the B2B
Head Assembly