Atdec Spacedec SD-DO Installation manual - Manual (Page 2)

No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 26.09.11 ©
Step 2. Remove VESA plate from Quickshift Donut
Step 5. Adjusting the VESA Ball Mount
Position your Display to the desired viewing angle, using the 40°
angular movement allowed by the VESA Ball Mount.
Depending on the weight of the display, it may be necessary to make
adjustments to the VESA Ball Mount. If the display does not hold its
position, or is too resistant, adjust the Tension Plate located at the
rear of the VESA Ball Mount (see diagram right).
To make any adjustments tension evenly using the 3mm Allen Key
supplied. Apply half a turn at a time to each screw on the Tension
Plate to adjust evenly.
Check the display, and then adjust again if necessary.
Installation Complete
Step 4. Attach your Display to the Quickshift Donut
Press and hold the Release Buttons (one on either side).
Release
Button
Whilst holding the Release Buttons, remove the VESA Plate.
LIFT
TIGHTEN
Hook the top of the VESA plate onto
the Quickshift Mount. (optional) Insert the Security Screw, and
tighten using a Phillips-head Screwdriver.
Back of Display
VESA Plate
Loosen (-Kg)
Tighten (+Kg)
Release
Buttons
3mm Allen Key
Tension
Plate
Step 3. Attach the VESA plate to your Display
There are two mounting hole configurations:
• 75 x 75mm
• 100 x 100mm
Choose appropriate Mounting Screws
from the Hardware supplied to suit
your Display.
Top of
Display
Mounting Screws (x4)
VESA Plate
Back of Display
75mm
(3”) 100mm
(4”)
75mm
(3”)
100mm
(4”)
VESA plate
Phillips-head
Screwdriver
Release
Button
Press and hold the Release Buttons. Gently
insert bottom of VESA Plate into Quickshift
Mount. Release
Buttons to lock
in place.