Atdec Visidec VF-WD Installation manual - Manual (Page 2)

Attach Head to Display C
Attach Display to Wall D
Adjust Display Position E
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 26.06.12 ©
OR
Step 1
Position the
Display & Bracket
over the Base. Step 2
Close the two halves of the Bracket
around the Base by firstly positioning
the top half and then the bottom half.
Step 3
Reassemble the Wall Direct Assembly
ensuring the weight of the display is
supported until the screw is tightened.
Tip: This step can be made
easier by using two people.
WARNING:
Do not
overtighten.
Step 1
Adjust the display to
the desired viewing
angle then lock it in
place by tightening
the tilt screw in the
direction shown.
Step 2
Adjust the display’s
position between
landscape and portrait.
The display can rotate
through +/-95º.
WARNING:
Do not
overtighten.
NOTE:
Screen does not
rotate 360°
Tighten
+/-95º
1
2
75x75mm VESA 100x100mm VESA
75mm
(3”)
75mm
(3”)
M4 screw
M4 screw
100mm
(4”)
100mm
(4”)