M-AUDIO Lagoon - Manual (Page 8)

Windows Driver and Software Installation
The Lagoon PCI includes a Windows 98/95 diskette containing the Windows
drivers, ASIO drivers, and Lagoon Tools Applet software. To install these on your
system, please follow these steps:
Windows 98 Installation
1. After installing the Lagoon hardware, boot your system and start Windows.
During the Windows boot procedure, new hardware will be automatically
detected by the Add New Hardware Wizard as shown here. Click ‘Next>’.
2. The ‘Add New Hardware Wizard’ will now ask how you want to find the driver.
“Search for the best driver for your device” is already selected. Click ‘Next>’.
3. Windows will give you a selection of locations to search. Make sure that ‘Floppy
disk drives’ is checked, or click on the check box to do so. Insert the Lagoon
95/98 Driver and Tools Applet Disk #1 into your floppy drive. Click ‘Next>’.
4. The ‘Wizard’ reports that its Windows driver file search has found the Lagoon
Audiocard. Click ‘Next>’.
5. Windows is now ready to install the driver files from the specified location.
Click ‘Next>’. Windows will start to copy the files and show you a progress
report screen.
6. The Wizard reports that Windows has finished installing the software. Click
‘Finish’. Your Lagoon is ready for action.
After completion of the driver installation, Windows may require you to restart
Windows. If it does request a restart, remove the Lagoon Disk from the floppy disk
drive and respond ‘Yes’. The system will restart and you are ready to install the
Lagoon Tools Applet software.
Windows 95 Installation
1. After installation of the Lagoon hardware, boot your system and start
Windows. During the Windows boot procedure, new hardware will be
automatically detected.
2. Choose the Install of “driver from disk provided by hardware
manufacturer,” then click ‘OK’.
3. An ‘Install From Disk’ will prompt you to copy files from the A:\ drive
(if your floppy drive is a different drive letter, then change it at this
time). Insert the Lagoon 95/98 Driver and Tools Applet Disk #1 into the
drive then click ‘OK’.
4. Windows will start to copy files, with a progress indicator on the screen.
Once this process completes itself, you will be ready to install the
Lagoon Tools Applet.
After completion of the driver installation, Windows may require you to restart
Windows. If it does request a restart, remove the Lagoon Disk from the floppy disk
drive and click ‘Yes,’ and the system will restart.
7