VTech CS6114-2 (with LED) Manual - Manual (Page 5)

2
Getting started
Telephone base and charger installation
Install the telephone base and charger as shown below.
Make sure that the electrcal outlet s not controlled by a wall swtch.
If you subscrbe to dgtal subscrber lne (DSL) hgh-speed Internet servce
through your telephone lne, you must nstall a DSL filter between the
telephone line cord and telephone wall jack. The filter prevents noise and
caller ID problems caused by DSL nterference. Contact your DSL servce
provider for more information about DSL filters.
Use only the power adapters and batteres suppled wth ths product.
To order a replacement, vst our webste at www.vtechphones.com or
call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call
1 (800) 267-7377.
The power adapters are ntended to be correctly orented n a vertcal
or floor mount position. The prongs are not designed to hold the plug in
place f t s plugged nto a celng, under-the-table or cabnet outlet.
•
•
Wall mounting
Your telephone comes ready for tabletop use. If you prefer to mount
your telephone on the wall (optonal), t s desgned to mount on a
standard telephone wall plate.
You can mount the telephone base on
the wall by postonng the top hole at the
back of the telephone base aganst the
top mountng stud [A]. Then slde the
telephone base down on the
mountng studs [A] and [B]
untl t locks nto place.
Telephone base
Telephone
lne cord
Electrcal outlet
(not controlled
by a wall swtch)
Telephone
wall jack
A DSL filter (not
ncluded) s
requred f you have
DSL hgh-speed
Internet servce
Telephone base
power adapter
Charger
Charger
adapter
CAUTION: If you subscrbe to telephone servce from a cable company
or a VoIP servce provder, contact your cable/VoIP servce provder for
more nformaton.
Mountng
studs
Telephone base
[A]
[B]