Veris Technologies MSP EC and pH (1997-2008 floppy disk drive 1.02E) - Operating Instructions User Manual
Page 4
Veris Technologies
Pub. #OM MSP03-1
4
Instrument Installation and Set-up
The Veris Instrument Kit includes the following items:
Mount instrument in a location that is as free as possible from dust, vibration, and electrical
interference. Display should be visible to operator and shielded from direct sunlight.
Below is a rear view of the instrument
Connect GPS cable to GPS INPUT serial port on back of instrument. The Veris instrument is
designed to accept GPS input in NMEA format via an RS232 connector. Note: GPS signals are
frequently affected by electrical interference from magneto electrical systems. If your vehicle uses a
Protective
case
EC and pH
Instrument
Mounting
Bracket
Power Cable
Trouble-shooting items:
Included with EC module:
EC signal test load
EC continuity test box
Included with pH module:
pH simulator
fuse kit
Keep these along with the
Operating Instructions with the
unit whenever collecting data.
serial port for
GPS signal
cable
serial port for
pH signal
cable or file
transfer
power
switch
power cable
port
signal port for
E.C signal
cable or test
load