Veris Technologies MSP EC and pH (1997-2008 floppy disk drive 1.02E) - Operating Instructions - Manual (Page 14)

Veris Technologies
Pub. #OM MSP03-1
14
If unit is equipped with hydraulic power pack, insert hydraulic ends into quick-couplers, being careful
to insert the end marked “P” into the pressure or oil output coupler, and the end marked “T” into the
tank or return line coupler. Note: if not using Veris-supplied hydraulic power pack, be certain that
tractor or hydraulic power source is equipped with open-center hydraulics. If tractor has closed center
hydraulics, make sure MSP is equipped with Closed Center Hydraulic Kit (part #26369) and that
poppet valve is in closed center position (in).
Fill gasoline engine and check engine and hydraulic oil levels.
Before filling tank with gasoline, let engine cool. Gas vapors can ignite
and an explosion can occur.
Checking the hydraulic fluid level is easy thanks to a sight glass on the hydraulic reservoir. The sight
glass is located on the front of the reservoir. Maintain the hydraulic fluid within 1/2 inch (1.25 cm) of
the upper (solid black) line on the glass. Remove the threaded plug from the filler neck to add fluid.
ALWAYS CHECK HYDRAULIC FLUID LEVEL WHEN FLUID IS COLD. DO NOT OVERFILL. See
Maintenance section for specifications on oil type and quantity. Checking the hydraulic fluid level on
the GS1000 is easy thanks to a sight glass on the hydraulic reservoir. The sight glass is located on
the front of the reservoir which is in turn located on the right side (as viewed from the front) of the
12 V Power leads
-raise-lower
-external control module
pH signal cable (if equipped)
EC signal cable
Closed center
hydraulic kit
poppet valve