Veris Technologies MSP EC and pH (1997-2008 floppy disk drive 1.02E) - Operating Instructions - Manual (Page 16)

Veris Technologies
Pub. #OM MSP03-1
16
Field Condition
Field should be in a uniform state. Mapping after intensive primary tillage is not recommended. The
soil must have a minimum of 10% available water, and cannot be frozen. If rocky conditions exist, you
may wish to consider the optional coulter rock guard kit , PN 15169.
Speed
Proper field operating speed depends on field conditions. Because of the importance of consistent
contact, the unit must not be allowed to bounce over rough fields at high speeds. On smooth fields,
the implement can be operated at speeds from 8-12 m.p.h. (12-18 km/hr)
Pulling Vehicle
The implement may be pulled with a variety of vehicles: 20-50 hp tractor, 4WD pickup or Jeep.
Swath width and Navigation
Setting the swath width and navigation system is at the discretion of the customer. A 40-60’ (12-18
m) swath works well in most areas. In areas of high soil variability, a narrower swath may be
preferred. Several methods of navigation are possible: following previous crop rows, swath guidance,
or using a field navigation computer. While it is important to map in a consistent pattern, it isn’t
absolutely critical that each pass be exactly the same distance from the previous pass.
Signal Cable
Attach the signal cable to the quick connect coupler at front of frame, and to Signal Port on back of
instrument
Adjustable Wing Extensions (XA option)
The MSP3150 with XA (Extendable Array): This option allows the re-positioning of the electrodes to
fit various bed and crop configurations. Adjustment is made by loosening the jam nuts and set
screws located on the lower front of each side of the toolbar, adjusting the toolbar wing extensions,
and re-tightening the set screws. Veris suggests setting the toolbars at either the maximum or
minimum setting, not at a point in between. A limiter bolt determines full extension, so there should be
no danger of extending to the point at which the outside coulters disconnect from the main frame.
Important – do not attempt to combine maps in which two different investigative depths are used.
operate
implement
parallel to
soil
adjust
toplink to
level