Veris Technologies pH Detector - Operating Instructions - Manual (Page 6)

OM17-pH Detector
2-3
Attaching pH Detector to ATV
Mount tank to rear rack of ATV using nylon straps or zip ties through holes in tank base(Figure 4).
Figure 5
Slide receiver hitch tubing inside lower main frame tube of pH Detector. If your ATV is equipped
with large receiver hitch, slide receiver hitch tubing directly into ATV receiver hitch and pin (Figure
5). If your ATV has a hole, or small receiver hitch, it will be necessary to use end of hitch tubing
with threaded holes. Attach L-bracket to these holes and bolt to ATV hitch hole (Figure 7).
Figure 6 Figure 7
Position pH Detector as close to rear of ATV as possible but don’t restrict probe movement. Attach
stabilizers to rear rack (Figure 8). These brackets can be bent to fit various racks. Once pH
Detector assembly is in position, tighten all bolts including hitch bracket bolts (Figures 5 and 6).
tighten bolts after
unit has been
positioned and
stabilizer arms
attached
ATV hitch