Veris Technologies pH Detector - Operating Instructions User Manual
Page 10
OM17-pH Detector
2-7
Important
– Do not allow moisture to enter the Sensor Data-Logger, and do not pass strong
magnets near the unit.
Mount instrument in a location that is as free as possible from vibration and electrical interference.
Use adjustable mounting brackets to position electronics for optimal visibility.
Figure 13
Attach 12 volt leads to battery, making sure not to reverse polarity. Route wires under tank and
seat but do not allow them to be pinched. Attach main power amp and power distribution cables
connector to pH controller.
Figure 14
Attach the serial communication cable from external pH controller to the pH port on back of
DataLogger.