Shogun Motorsports Kawasaki ZX6R (07-08) Frame Slider - Manual

Kawasaki ZX6R 07-08 Frame Slider Installation
Instructions
Part Numbers: 750-4419, 755-4419, 750-4410,
850-4410
MADE IN THE USA!
Carefully read instructions in their entirety before the install
Professional installation is recommended. Always use proper safety measures during the install of this
product. Do not try to install this product without proper tools, recently calibrated torque wrench,
correct torque specifications from
factory service manual , safety goggles and gloves. The motorcycle
must be in a fixed secure position before the install process begins. DO NOT remove both engine studs
at the same time.
Shogun is not responsible for any part of your motorcycle for any reason. If you have
any questions please call us directly for assistance.
Replacement Parts List: Left Side Components (as if you were sitting on the bike)
QTY
Price each Part Numbers Descriptions
1
$20.00 99-FS-750-4419-L Black Left Side Puck
1 $20.00 99-FS-750-4410-L White Left Side Puck
1 $30.00 99-FS-850-4410-L Polished Billet Left Side Puck
1 $15.00 99-SP-750-4410-L Left Side Bell Type Spacer Black Anodized
1 $3.50 99-HB-SH10125090 Socket Cap 10 X 1.25 X 90 Main Engine Stud
Replacement Parts List: Right Side Components (as if you were sitting on the bike)
1
$20.00 99-FS-750-4419-R Black Right Side Puck
1 $20.00 99-FS-750-4410-R White Right Side Puck
1 $30.00 99-FS-850-4410-R Polished Billet Right Side Puck
1 $30.00 99-OF-750-4410-R Right Side Offset Black Anodized
1 $2.00 99-HB-SH10150045 Socket Cap 10 X 1.5 X 45 (Holds puck to offset)
1 $3.50 99-HB-SH10125070 Socket Cap 10 X 1.25 X 70 Main Engine Stud
Frame Sliders: Left frame slider longer than right
Installation Steps:
1.
Locate and remove left engine stud. Tip: The left side engine stud on the ZX6R tends to be very
tight from the factory, use a stubby socket to remove stud. Make sure you have good
engagement or the head of the bolt can strip.
2.
The small end of the (99-SP-750-4410-L Left Side Bell Type Spacer Black Anodized) goes against
the left side of the frame. The longer of the two frame sliders goes on top of the spacer. Using
the 10 X 1.25 X 90 Socket Cap mount and torque down to OEM specs.