Shogun Motorsports Kawasaki Ninja 1000 (11-13) NO CUT Frame Slider - Manual (Page 3)

Start by removing the lower cowling first (Note: If you have any issues removing the body work, double
check to make sure all rivets and bolts have been removed)
While removing the mid panels you will need to unplug each turn signal as pictured
2.
Remove the right side engine bolt as pictured.
3.
Install the right side offset using the 10x1.25x90mm bolt; lightly tighten up the bolt. Mount the
right side body panel and position the offset so the slider puck will clear the bodywork. Mount
the right side slider puck onto the offset using the 10x1.50x45 bolt to ensure correct location.
Remove the slider puck and body work and torque down the offset bolt to the OEM engine bolt
torque specifications.