Shogun Motorsports Kawasaki ZX6R_RR (05-06) Frame Slider - Manual (Page 2)

4.
Remove the left side OEM motor mount bolt.
5.
Some photos in this section are used for illustration examples only. It is up to you how you
decide to cut your motorcycles bodywork to accept the frame slider there are many different
ways customers go through this process.
Shogun is not responsible for any part of your
motorcycle for any reason. Precisely measure location of cut and if in doubt at any point please
call us before the install process has begun. Professional installation is recommended. Always
use proper safety measures during the install of this product. Do not try to install this product
without proper tools, recently calibrated torque wrench, correct torque specifications from
factory service manual,
safety goggles and gloves.
6.
How we do it here: We use the bolt supplied in the kit along with the bell type spacer. We slip
the bolt though the bell spacer (big end out like shown in picture below) then loosely mount the
bodywork over it. Prep body with protection where you will be cutting. In the second picture
(orange body) you can see the bell type spacer behind the body. We do this so we can see about
where the cut needs to be.
7.
Using a sharpie pen we make a point where the center of the engine stud would be. (picture 3 rd
to the right shown above)
8.
For this application we used a Dremel tool with a sanding roll to open up the hole little by little.
MAKE SURE YOU WEAR PROTECTIVE GOGGLES AND GLOVES As you cut and open the hole to
your scribe marks keep checking that the hole is lining up with your puck dimension.