Shogun Motorsports Kawasaki Ninja 300R DMP Fender Eliminator Instructions - Manual (Page 5)

Moto911 Inc. - 1062 Calle Negocio, Ste. J, San Clemente, Ca. 92673 – (949)453-9111
15. Lay out the DMP Fender Kit and organize it as seen below
16. Take two of the 6x16mm bolts and 2 of the larger 6mm washers and place it through the plate
shown below
17. Holding the bolts in place flip the bracket upside down and place through the fender holes
underneath the tail section. Place the larger 6mm washers over the bolts on the inside and
screw on the lock nuts. Using a socket wrench on one side and an allen wrench on the other
torque down the bolts. Do not over tighten, the lock nuts have nylon to keep from coming
loose.
18. Line the bottom plate up with two open holes of the plate that was just installed (the wires
shown in this picture are from the DMP marker lights installed to the fender plate)