High Lifter Radiator Relocation Kit - Can-Am Outlander 500_650_800_1000 - Manual (Page 7)

14. For the rear of the rack fasten it to the rack by placing a ¼” washer on the ¼ x 1 ¼” hex
bolt. Insert the bolt through the relocation kit and opening in the rack.
15. On the underside of the rack place the large 1 ¼” fender washer on the bolt and fasten it
with the ¼” lock nut.
16. Locate the sock 90° hose that is connected to the top of the thermostat housing. Remove
it from the hosing and set aside for use in another location. Also disconnect the hose that
was connected to the radiator and is connected to the T-fitting and discard it as it is no
longer needed.