High Lifter Radiator Relocation Kit - Can-Am Outlander 500_650_800_1000 - Manual (Page 3)

Installation Instructions
1. Remove seat, steering pod and the inner fender from the ATV. You will need a rivet tool
to remove plastic.
2. Drain the stock radiator and dispose of used fluid according to your local regulations.
Use care in disposal, antifreeze is toxic.
3. Remove the stock radiator and unplug the fan from the ATV.
4. Remove the stock overflow bottle and the radiator inlet hose that connects it to the
radiator. You will relocate the bottle to the new radiator relocation frame.
5. Once you have removed the radiator from the frame you will need to insert it into the
face plate of the relocation kit. Insert the stock rubber grommets that are located on the
bottom of the stock radiator into the mounting holes on the face plate. Slide the radiator
in from the left side of the face plate. This may take a little effort, but should slide into
place. Once it is in place secure the radiator to the face plate using the 6x25mm hex
bolts, ¼” flat washers, and 6mm lock nuts.