High Lifter Lift Kit for Polaris Ranger RZR 900 XP - Signature Series 5 - Manual (Page 6)

Rear Lift Installation
1. Place ATV transmission in park. Lift the rear of the RZR until the rear trailing arms drop to
full extension and tires leave the ground.
2. You will need to remove the rear wheels and all rear plastic.
3. You will also need to remove the stock axles.
4. The next step is VERY IMPORTANT! You will need to grind a small area on the trailing
arms to have clearance for the CV boots. If you are installing aftermarket axles you may
have to grind substantially more material for CV boot clearance.
NOTES:
• Make sure to grind enough for clearance
• Axles will need to go back in before you reattach the shocks
• You will need to fully reassemble the rear to check for clearances so make sure you get enough the
first time.
• Once it is reassembled, leave the rear jacked up with trailing arms at full extension and lift installed,
rotate the tires to see if the boots clear.
• If they do not clear you will need to completely disassemble and grind more material.
5. Now you will need to relocate some wires that run along the rear left side frame where the
lift brackets will be attached. Use the zip tie provided in the kit to reattach the wires.