EVS IPDirector Version 5.8 - July 2010 Part 2 User's Manual - Manual (Page 53)

Issue 5.8.B IPDirector Version 5.8 – User Manual – Part 2 – Logging
EVS Broadcast Equipment – July 2010
42
Important
In this case, new log entries, made after entering the offset, will not
have the offset applied to them. Entering the T/C Offset should only be
done when the log sheet is completely finished.
H
OW TO
S
YNCHRONIZE A
L
OG
S
HEET FROM A
L
OADED
I
MAGE
The user can apply an offset on all the logs to synchronize the log sheet and the
clips. To do so, proceed as follows:
1. Associate a player channel to IPLogger. See section
2. Open a Control Panel and associate the same player channel to it.
3. Load the log on the Control Panel. See section
4. Move through the media until you reach the image corresponding to the log.
5. Right-click the log line in the log sheet.
The Log contextual menu is displayed.
6. Select Synchronise this log with the image loaded on the player from the
menu.
All the timecodes are reset.
1.8.1 H
OW TO
A
PPLY A
T/C O
FFSET AT
L
OG
E
NTRY
If the operator is slow or he is logging on a delayed feed, he can decide to apply
an offset at log entry. This offset is defined in a user setting. The offset is applied
to the T/C when the user creates the log. To do so, proceed as follows:
1. Select Tools > Settings > IPLogger.
2. In the Apply a T/C offset at log creation on a live feed field, enter a value
in msec for the offset.
3. Press OK.
Each time you will create a new log, the offset will automatically be applied to the
log timecode:
‘Log timecode = timecode when you have click the New button – offset value’
1.8.2 A
PPLYING A
T/C O
FFSET AT
A
UTOMATIC
L
OG
E
XPORT
When defining a directory for automatic log export in the remote installer, an
offset can be specified. This could be, for example that the two setups are in
different time zones. Refer to the Technical Reference manual for more
information.