EVS XFReader Version 2.6 - October 2013 User Manual - Manual (Page 11)

USER MANUAL OpenCube XFReader 2.6
Introduction 9
1. Run setup.exe from the OCPackage\windows folder.
This will install the OpenCube KeyManager application, if it is not already available.
OpenCube KeyManager is the root of OpenCube’s application and license
management system.
OpenCube KeyManager will be launched.
2. Click on the active “Install” button located on each product line. The screenshot below
illustrates the installation of an evaluation version of OpenCube XFReader.
For minimum configuration, OpenCube GXFTk® Reader (the GXF DirectShow filter),
OpenCube
XFReader (the application), the MainConcept’s DShow filters and
OpenCube’s DShow filters must be installed.
Note
OpenCube MXFTk® Reader is no longer required.
To playback through the SDI Output (available as an option), you have to install a
compatible SDI card (see 1.2 - Minimum Hardware Requirement and 6 - SDI Board
Installation Procedure). If you encounter any problem with the driver installation do not
hesitate to contact the OpenCube XFReader support team (
[email protected] ).
1.5 License Activation
Once all the components have been installed, use the “Load license file” button to load
your license file. If the license is distributed with the package, it can be found in the
OCPackage\Licenses folder.