AASTRA 600d (GAP) User Manual EN User Manual

Page 62

Devices menu

Alarm auto answer

You can specify whether a call from any call number should be answered auto-
matically during the pre-alarm. Regardless of the setting, calls from the alarm
number or SOS emergency number are answered automatically and the pre-
alarm is terminated.

Alarm tone The pre-alarm can be sounded with or without an alarm tone on the handset. If

the alarm tone is activated, the signalling volume increases progressively.

Handsfree in alarm

You can specify whether the alarm call can be made in handsfree or handset
operation. This setting also applies to the emergency call using the SOS / emer-
gency call key.

Pre-alarm You can set the time that should elapse before the emergency number is dial-

led. An increasingly loud ring tone (alarm tone) is signalled on the handset
during this time (provided it is not deactivated). The alarm can still be cancelled
during the pre-alarm (off, 10 s ... 60 s).

Repeat alarm

This is the amount of time after which a new pre-alarm is made followed by the
dialling of the alarm call number, for instance because the dialling of the alarm
call number was cancelled (off, 5 s... 240 s).

Mandown Status: Indicates whether or not “mandown” is activated.

Press the Change softkey to activate or deactivate.
Delay: Allows you to set the amount of time the handset can remain outside
the vertical position before a pre-alarm is triggered (1 s … 60 s).

No movement alarm

Status: Indicates whether or not the no movement alarm is activated.
Press the Change softkey to activate or deactivate.
Delay: Allows you to set the amount of time the handset can remain still
without before a pre-alarm is triggered (10 s … 60 s).
Sensitivity: Allows you to set the sensitivity (low, medium, high). This allows
you to adapt the sensor to the different movements (e.g. ways of walking) of
the surveillance personnel. Switch off vibra call if you want to use the no move-
ment alarm.

Escape alarm

Status: Indicates whether or not the escape alarm is activated.
Press the Change softkey to activate or deactivate.
Delay: Allows you to set the amount of time the handset can be in rapid move-
ment before a pre-alarm is triggered (1 s … 60 s).