Garmin GPSMAP 5215 - Manual (Page 108)

104 GPSMAP ® 4000/5000 Series Owner’s Manual
Appendix
Saving System Information to a Memory Card
You can save system information to a memory card as a troubleshooting tool. A Garmin Product Support
representative may ask you to use this information to retrieve data about the marine network.
1. Insert a memory card into the Data card slot on the chartplotter.
2. Select Configure > System > System information > Garmin Devices > Save to Card.
3. Remove the memory card.
Restoring the Original Chartplotter Factory Settings
Note: This procedure deletes all settings information you have entered.
1. From the Home screen, select Configure > System > System information > Factory Settings > Reset.
2. Select Yes.
Communication with Wireless Devices
Connecting a Wireless Device
You can allow wireless devices, such as a remote control or an optical mouse, to communicate with the
chartplotter.
From the Home screen, select Configure > Communications > Wireless Devices > New Connections >
Yes.
Disconnecting a Wireless Device
1. From the Home screen, select Configure > Communications > Wireless Devices.
2. Select a wireless device.
3. Select Disconnect.
Garmin Marine Network
The Garmin Marine Network allows you to share data from Garmin peripheral devices with Garmin
chartplotters quickly and easily. You can connect a GPSMAP 4000/5000 series chartplotter to a Garmin
Marine Network to receive data from and share data with other Marine Network-compatible devices and
chartplotters.
Transferring Data over the Garmin Marine Network
See “Chartplotter Data Management” ( page 60 ).
Configuring Networked Devices
See “Networked Device Configuration” ( page 62 ).
NMEA 0183 and NMEA 2000
A GPSMAP 4000/5000 series chartplotter can accept data from both NMEA 0183-compliant devices and
certain NMEA 2000 devices connected to an existing NMEA 2000 network on your boat.
NMEA 0183
The NMEA 0183 data cable included with each GPSMAP 4000/5000 series chartplotter supports the NMEA
0183 standard, which is used to wire various NMEA 0183-compliant devices, such as VHF radios, NMEA
instruments, autopilots, wind sensors, and heading sensors.
A GPSMAP 4000/5000 series chartplotter can receive data from up to four NMEA 0183-compliant devices
and send GPS data to up to six NMEA 0183-compliant devices.
To wire the GPSMAP 4000/5000 series chartplotter to optional NMEA 0183-compliant devices, see the
GPSMAP 4000/5000 Series Installation Instructions.