Replacing back upholstery, Replacing seat upholstery – Activeforever Invacare Tracer IV Wheelchair User Manual
Page 34

SECTION 6—SEAT AND BACK
Tracer
®
IV
34
Part No. 1110558
SECTION 6—SEAT AND BACK
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.
Replacing Back Upholstery
NOTE: For this procedure, refer to FIGURE 6.1.
1. Remove the eight mounting screws and
washers that secure the existing back
upholstery to the back canes.
2. Remove existing back upholstery from
the back canes.
3. Securely tighten the new back
upholstery to the back canes with the
mounting screws and washers.
FIGURE 6.1 Replacing Back Upholstery
Replacing Seat Upholstery
NOTE: For this procedure, refer to FIGURE 6.2.
1. Perform one of the following:
• 18-Inch Deep Seats: Remove the ten mounting screws and washers that secure the
existing seat upholstery to the crossbraces.
• 20-Inch Deep Seats: Remove the twelve mounting screws and washers that secure
the existing seat upholstery to the crossbraces.
2. Remove the existing seat upholstery
from the crossbraces.
3. Ensure positioning of seat positioning
strap (if used). Refer to Installing the
Seat Positioning Strap on page 51.
4. Install new seat upholstery by
reversing STEPS 1-2.
FIGURE 6.2 Replacing Seat Upholstery
Washers
Back Upholstery
Washers
Mounting
Screws
Mounting Screws
Wheelchair
Frame
Seat
Upholstery
16-inch
Seat Depth