Acroprint AcroComm - Manual (Page 45)

AcroComm Programming Manual
MMM..: 16 character message
A: Allow check (Y-Yes, N-No)
S: Allow supervisor access
B: Emission bell (A-Accepted, R-Rejected, N-None)
T: Displayed Message Time
6.2.47. RA
Register Invalid Transactions
Format: RA=F
where
F: Y or N, 1 or 0
An invalid transaction will cause an X character to appear on the function
field.
When set to Y or 1, the invalid transactions will be stored in the terminal, in
the following cases:
The profile lockout rejects the transaction (puts a ‘5’ mark on
transaction record, 2
nd field)
The badge that is swiped does not have a fingerprint stored (‘6’ mark)
The fingerprint read does not match the one stored for the badge (‘7’
mark)
The badge that is swiped does not have a PIN assigned or the PIN
entered is incorrect (‘8’ mark)
A proximity card was detected with an incorrect facility code (‘9’ mark)
6.2.48. RL
Printer Reset line
Format: PX=MMMMM…
where
MMM..: up to 30 Characters
After a transaction is printed, the reset line is sent to the printer. This string
accepts any control character that had to be sent to the printer to reset it or to
perform any action after the printing.
6.2.49. RST
Transaction Memory Initialization
Format: RST
This instruction eliminates all transactions from the clock’s memory
6.2.50. SG
Maximum Number for Swipe & Go
Format: SG=XXXX...
Badge numbers included between numbers 0 and XXXX... will be considered
for Swipe & Go. These badges do not execute any functions.
45