Acnodes KDM 7178 - Manual (Page 46)

KDM series User’s Manual
41
Recommend Power ON sequence as follows: Monitor, KVM Switch, finally
Computer.
2.5 CAT5 KVM Receiver
The CAT5 KVM receiver uses CAT5 cable to extend your keyboard, mouse
and monitor 1000 feet (300 meters) away from the KVM switch. It also has
built-in 2-to-1 OSD KVM switch for selecting remote or local Computer.
2.6 CAT5 Receiver Installation
1. Make sure the CAT5 cable is straight through type.
2. Plug one end of CAT5 cable into RJ-45 connector of the KVM switch CAT5
console port, and plug the other end of CAT5 cable into RJ-45 port of the
R-Box.
3. Connect keyboard, mouse and monitor to the R-Box console ports (USB
Keyboard/Mouse ports, and VGA port)
4. Connect Local Computer to R-box with the accompanied 3-in-1 HDDB-15
cable.
5. Power on the R-Box by plugging in the power adaptor
6. Push the SELECT button to select remote or local Computer.
2.7 When video signal is foggy or unclear
The CAT5 Receiver enables user to access to the computer, server, or KVM
switch up to 1000 feet (300 meters) away with superior auto-adjust RGB
gain/delay control capability
CAT5 cables has CAT5, CAT5e, CAT6 and STP/UTP types; If your application
need high VGA resolution and long distance please select high end cables.
It is highly recommended to use optimal CAT5 cable length to get the best video
quality and not waste unnecessary CAT5 cable.
2.8 Daisy Chain Connection
Use one end of daisy chain cable to connect to the Daisy Chain port of Master
KVM switch and connect the other end of daisy chain cable to the Local