Accusys ExaRAID A24U-SJ - Manual (Page 25)

23
JBOD System
Quick Start Guide
Step 6: Configuring the JBOD system
Configuring Host Server Connection
Figure 1-2 shows an example of two A16R-SJ connected to the host
server.
To configure the connection using Windows, follow the procedures
below:
1.Open the folder with the installation files for Windows 32-bit or 64-bit.
2.To check the configuration, open Computer Management > Device
Manager.
• Check if all the hard disk installed in the JBOD are detected.
Note
The following procedures are based on Windows server 2003 R2.
Make sure you are installing in Windows 32-bit or 64-bit.
TV OUT
Controller A
Controller B
Controller A
Controller B
SAS Card
Host Sever
Figure 1-2 Host server connection with JBOD expansion