Carrier 42XQ_42XQA User Manual

Page 17

NOTE

Setting the hour
(Button N)

1. With the remote control

connected or disconnected,
press button .

2. The numbers of the hour

start flashing. Press button
or to set the desired
hour.

Press button to switch to
the minutes, in order to set
them.

3. To make this selection,

always use buttons or .

4. After setting the hour, press

button to confirm.

NOTE

“Address” Selector

• If there are two indoor units in the

same room, you can connect one
remote control to one indoor unit and
the other remote control to the other
unit, or you can control both units
using just one remote control.

• For the configuration, consult the

Installation & Start-up Instruction’s
Manual.

The air conditioner will not work if there are
curtains, doors or other objects blocking the
signal sent from the remote control to the
unit.

If the infrared signal receiver of the indoor
unit is directly exposed to the sun’s rays,
the equipment will not function properly.
Block the incidence of sunlight until the
exposure has been eliminated.

Together with the remote control, you will
receive a mounting support to put it inside.
Attached the support to the wall.

CAUTION !!!

• Always use the remote control to set the

position of the air deflectors; otherwise
operational anomalies may result.
Disconnect the unit and reconnect it
when manually setting the grid outside
of the range.