HONDA 2008 Pilot - Manual (Page 280)

Insert the hoist bracket into the
center hole of the flat tire.
Slowly turn the wheel nut wrench
clockwise to take up the slack of
the hoist cable. Make sure the
bracket is seated in the center
hole of the flat tire.
Turn the wheel nut wrench
clockwise until the flat tire rests
against the underbody of the
vehicle and you hear the hoist
click.
Store the jack in its holder. Turn
the jack’s end bracket to lock it in
place. Replace the cover. Store the
tools.
Refer to
(see page ).
17.
18.
19.
20.
21.
213
Changing a Flat Tire
Changing a Tire with
TPMS
276
WHEEL NUT WRENCH
Loose items can fly around the
interior in a crash and could
seriously injure the occupants.
Store the wheel, jack, and tools
securely before driving.
Always raise the spare tire hoist, even
if you are not stowing a tire. If the
hoist is lef t down, it will be damaged
during driving and need to be replaced.
2008 Pilot
Table Of Contents Main Menu