HONDA 2008 Pilot - Manual (Page 139)

When using CD-R discs, use only
high quality CDs labeled for audio
use. When a CD is not being played, store
it in its case to protect it from dust
and other contamination. To prevent
warpage, keep CDs out of direct
sunlight and extreme heat.
To clean a CD, use a clean soft cloth.
Wipe across the CD from the center
to the outside edge.
A new CD may be rough on the
inner and outer edges. The small
plastic pieces causing this roughness
can flake off and fall on the re-
cording surface of the CD, causing
skipping or other problems. Remove
these pieces by rubbing the inner
and outer edges with the side of a
pencil or pen.
Handle a CD by its edges; never
touch either surface. Do not place
stabilizer rings or labels on the CD.
These, along with contamination
from fingerprints, liquids, and felt-tip
pens, can cause the CD to not play
properly or possibly jam in the drive.
Never try to insert foreign objects in
the CD player or the CD changer.
When recording a CD-R or
CD-RW, the recording must be
closed for it to be used by the
system.
Play only standard round CDs.
Odd-shaped CDs may jam in the
drive or cause other problems.
Handle your CDs properly to
prevent damage and skipping. See
this page.
General Inf ormation Protecting Discs
Protecting Your Discs
Fe
a
tu
re
s
135
Do not use discs with adhesive labels.
The label can curl up and cause the
disc to jam in the unit.
2008 Pilot
Table Of Contents Main Menu