HONDA 2008 Pilot - Manual (Page 189)

Make sure you have properly
completed the ‘‘Training
HomeLink’’ procedure.
location will vary, depending on
the manufacturer.
Press and hold the button on
HomeLink for 3 to 4 seconds.
for about 1 second. It should
operate the garage door.
The ‘‘Training HomeLink’’
procedure trains HomeLink to the
proper garage door opener code.
The following procedure
synchronizes HomeLink to the
garage door opener so it sends and
receives the correct codes.
For security purposes, newer garage
door opening systems use a ‘‘rolling’’
or variable code. Information from
the remote control and the garage
door opener is needed before
HomeLink can operate the garage
door opener.
garage door opener unit until the
indicator next to the button comes
on. The indicator may blink, or
come on and stay on. You then
have approximately 30 seconds to
complete the following steps.
2.
4.
1.
Training With a Rolling Code
System
Fe
a
tu
re
s
185
TRAINING BUTTON
Homelink ® Universal Transceiver
garage door opener unit. The
Find the ‘‘learn’’ button on your
3. Press the “learn” button on the
5. Press the HomeLink button again
If the button works,
programming is complete.
If the button does not work go
operate any other compatible
remotely controlled device around
your home (lighting, automatic
gate, security system, etc.).
pushing it for about 1 second.
to step 5.
5. Push and hold the HomeLink
for 2 seconds then stays on, you
Code System’’ (see page 185 ).
button and watch the red indicator
on Homelink.
If the indicator stays on, press
If the indicator flashes rapidly
the Homelink button again; the
have a rolling code transmitter:
should operate.
remotely controlled device
other two HomeLink buttons to
go to ‘‘Training with a Rolling
6. Repeat these steps to train the
4. Test the Homelink button by
2008 Pilot
Table Of Contents Main Menu