HONDA 2008 Pilot - Manual (Page 188)

Press and hold the remote
transmitter button and one of the
HomeLink buttons at the same
time.
transmitter button and one of the
time. While continuing to hold the
HomeLink button, press and
release the remote transmitter
button every 2 seconds.
If the red indicator in HomeLink
continues to flash slowly (does
not flash rapidly), your remote
transmitting after a short time.
If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
If the red indicator in HomeLink
then rapidly, release both
If the red indicator in HomeLink
not begin to flash rapidly),
184
Homelink ® Universal Transceiver
2.
buttons, and go to step 4.
Go to step 3.
transmitter may stop
Press and hold the remote
HomeLink buttons at the same
begins to flash slowly at first,
3.
buttons, and go to step 4.
repeat steps 1 thru 3.
continues to flash slowly (does
If you just
received your vehicle and have not
trained any of the buttons in
HomeLink before, you should erase
any previously learned codes before
training the first button. To do this,
press and hold the two outside
buttons on the HomeLink
transceiver for about 20 seconds,
until the red indicator flashes.
Release the buttons, then proceed to
step 1.
If you are training the second or
Hold the end of the garage door
inches from HomeLink. Make
sure you are not blocking your
view of the red indicator in
HomeLink.
1.
Bef ore you begin
third buttons, go directly to step 1.
opener remote transmitter 1 to 3
Training HomeLink
2008 Pilot
Table Of Contents Main Menu